What a re-roof in Claremont has to comply with

California rules that apply here too

These are not specific to Claremont, but they apply to it, and several of them are widely got wrong — including by contractors quoting from habit rather than from the current code.

Fire classification: what is actually required, and where

The statewide floor is a Class C fire-retardant roof covering. That applies to a new roof, to any repair or replacement, and to any existing building where more than half the roof area is replaced within a year — which is every ordinary re-roof.

Class A, the highest classification, is required where the property sits inside a fire hazard severity zone or a wildland-urban interface area, and many cities require it more widely by local ordinance. In practice, across most of south Orange County, Class A is the answer — but it comes from the fire zoning and the local ordinance rather than from a blanket statewide rule, so it is worth confirming for your address rather than assuming either way.

As of 1 January 2026 the wildfire rules live in their own book: the California Wildland-Urban Interface Code, Title 24 Part 7, which consolidated what used to be Chapter 7A of the building code and section R337 of the residential code. A contractor still citing Chapter 7A is citing something that has been superseded.

Licensing, deposits and what has to be on the paperwork

Roofing sits under the C-39 classification at the Contractors State License Board. The small-job exemption that permits unlicensed work rose to $1,000 in January 2025, but it does not extend to work needing a permit, and a re-roof needs one. So the rule that matters is the simple one: a re-roof requires a licensed contractor, at any price.

Deposits are capped by statute at $1,000 or ten per cent of the contract, whichever is smaller, unless the contractor carries a blanket performance and payment bond with the board. Going over it is a misdemeanour, and in a declared disaster area the court must impose the maximum fine — which says something about how often it is tried after a storm.

Licence numbers are required in all advertising and on contracts, subcontracts and bids. An advert without one is itself information. The board’s register settles it in under a minute and the minute is worth spending.

The code your roof will be built to

The rules a California re-roof is built to live in Title 24, the state building standards code. Its 2025 edition governs any project whose permit application went in on or after 1 January 2026. A roof installed before that date was built to an older edition, and not everything acceptable then is acceptable now.

This is practical rather than academic. A contractor quoting from memory instead of from the edition currently in force will occasionally price a detail that will not pass — and the inspection comes at the end of the job, not the beginning.

What a wildfire-zone roof actually has to include

In a mapped fire hazard zone the requirements reach well past the covering, and they are the details that separate a compliant roof from a cheap one. Embers, not flame fronts, are what destroy most houses in a wildfire, and every one of these requirements is about closing a gap an ember could get through.

• A roof assembly meeting Class A when tested to ASTM E108 or UL 790
• On profiled tile, bird stops at the eaves and hip and ridge caps mudded in, so there is no open end for embers to enter
• Valley flashing of at least 0.019 inch (26 gauge) corrosion-resistant metal, over a mineral-surfaced cap sheet at least 36 inches wide
• Noncombustible gutters and downspouts, with an approved means of stopping leaves and debris collecting in them
• Vent screening of noncombustible corrosion-resistant mesh, no finer than 1/16 inch and no coarser than 1/8 inch